Grado Red3, kartridžas
Grado Red3, kartridžas - prieš pirkdami pasiteiraukite ar šią prekę turime sandėlyje, jei neturime ji gali būti užsakyta ir atvykti per 2-21 dieną.
▪️ Turite klausimų dėl šios prekės❓Galime pakonsultuoti telefonu +370 683 90000, arba mūsų salone Armatūrininkų g. 1, Kaunas.
📩 Taip pat galite siųsti mums užklausą į kurią atsakysime per 24 val.
Nemokamas pristatymas Lietuvoje nuo 100 €
Nemokamas pristatymas Lietuvoje nuo 100 €
Lietuvoje Venipak kurjeriu pristatymas per 1-2 darbo dienas.
Pristatymas už Lietuvos ribų per 4-10 darbo dienų.
Atsiimkite prekes parduotuvėje už 0 €
Atsiimkite prekes parduotuvėje už 0 €
Armatūrininkų g. 1, Kaunas
Darbo laikas: I-V 9:00-18:00
Grado Red3, kartridžas
- INFORMACIJA
- APRAŠYMAS
- TECHNINIAI DUOMENYS
Prestige serijos, prabanga, išskirtine surinkimo kokybe (surinkta rankomis) pasižymintis kartridžas iš Grado.
- Kartridže naudojamos tik prabangiausios medžiagos.
- Dažnių juosta: : 10-55,000 Hz
- Dvigubo magneto sistema.
- Flux-Bridge™ technologija.
- Kontileveris: Deimantinis galiukas.
Awesome sound in red states and blue states
Hand-Built in Brooklyn
Diamond Tipped
Twin Magnet System
Patented Flux-Bridge™
Ultra High Purity Copper Coil
Four Coil Unison
De-Stressed Chasis
Swiss Screw Machined
Both the Blue3 and Red3 use a four piece OTL cantilever that has a Grado specific diamond mounted on a brass bushing. The Red3 are hand selected from Blue3 production runs which meet higher test specifications. Approximately 10% of the run usually exhibits these specs and become a Red3. Grado’s OTL, or optimized transmission line, technology provides an ideal transfer of signal from the surface of the LP to the generator of the system. This technology rejects unwanted resonances and lowers distortion preserving the fundamental and harmonic frequencies of the music. This also helps keep noise generated by the motor system in the cartridge to a minimum.Grado’s OTL stylus/cantilever design makes records sound quieter, improves the height, width, and depth of the soundstage, and present more detail than previously obtainable.
The Red3 & Blue3 are all hand assembled by our team in Brooklyn, with some builders having over 25 years of experience. With the recent development of the highly received Lineage Series of cartridges, we were able to have a trickle down of technology and bring a new technique to the Red3 & Blue3. This updated series of cartridges offers excellent tonal balance, dynamics, and realism, for a most rewarding reproduction of vocals and instruments. Our coil winding techniques, using ultra high purity copper wire which were honed during the development of the Lineage Series, have let the electrical circuits achieve unison between the four coils in each phono cartridge. This allows for a precise balance between channels and accurate stereo imaging.
As in all Grado phono cartridges the Red3 & Blue3 are powered by a twin magnet system that optimizes the balance between stereo channels. All internal magnetic circuit parts are held to extremely high tolerances creating the desired stereo imaging. Grado’s patented Flux-Bridger design allows the Red3 & Blue3 to have one of the lowest effective moving mass generating systems while creating an excellent balance throughout the full frequency range.
The development of the Epoch in the Lineage Series gave us an in-depth experience with using an outer housing as a damping device. This led to the creation of a process which de-stresses the chassis and dissipates unwanted energy & resonant frequencies, allowing the desired signal to travel freely.
The Grado Prestige Red is proof that one does not have to spend large amounts of money for good sound from a phono cartridge.
SPECIFIKACIJOS
- Frequency Response: 10-55,000 Hz
- Principal: MI
- Channel Separation at 1KHz: 30
- Input Load: 47K
- Output at 1KHz 5CM/sec.: 5mV
- Recommended Tracking Force: 1.5
- Stylus Type: E
- Inductance: 45mH
- Resistance: 475
- Compliance CUs: 20
- Stylus Replacement: U
- Mounting: S/P
- Weight: 5.5
